Oscilloscopes User's Guide

300 6000 Series Oscilloscope User’s Guide
6 Displaying Data
To decode UART/RS232 data
1 Select the UART/RS232 serial decode mode:
a Press the Acquire key.
b Press the Serial Decode softkey.
c In the Serial Decode Menu, press the Mode softkey.
d Use the Entry knob (or repeatedly press and release the
Mode softkey) to select the UART/RS232 serial decode mode
if it is not already selected.
NOTE
Because of oscilloscope hardware resource limitations, you cannot
decode UART/RS232 data while CAN, LIN, or FlexRay triggering is
selected.
NOTE
For UART/RS232 triggering setup see page 199.
Display
decode
Decode
mode
Signal
setup menu
Return to
previous menu
Frame
counter
reset