User`s guide

Reference 7
5000 Series Oscilloscope User’s Guide 273
To set up the I/O port
The oscilloscope can be controlled via GPIB, LAN, or USB. By
default, all three are active, although they can be selected or
disabled using the Control softkey in the I/O menu (press
Utility
&I/O).
The oscilloscope’s I/O configuration, including its IP address
and hostname, can be viewed by pressing Utility
&I/O.
To change the I/O controller settings, press the Configure softkey,
and choose the I/O connection type (GPIB, LAN, or USB).
For instructions on setting up the oscilloscope to run from a
controller via LAN, GPIB, or USB, see the Programmer’s Quick
Start Guide.
To check warranty and extended services status
To learn the warranty status of your oscilloscope:
1 Point your web browser to:
www.agilent.com/find/warrantystatus
2 Enter your product’s model number and serial number. The
system will search for the warranty status of your product
and display the results. If the system cannot find your
product’s warranty status, select Contact Us and speak with
an Agilent Technologies representative.