Technical data

692 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

7 Obsolete and Discontinued Commands

:MEASure:VSTOp

(see page 750)

Command Syntax

:MEASure:VSTOp <vstop_argument>

<vstop_argument> ::= value for Y2 cursor

The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to

the specified value corresponding to the selected source. The source can

be selected by the MARKer:X2Y2source command.

Query Syntax

:MEASure:VSTOp?

The :MEASure:VSTOp? query returns the current value of the Y2 cursor.

Return Format

<value> ::= value of the Y2 cursor in NR3 format

See Also • "Introduction to :MARKer Commands" on page 275

• "Introduction to :MEASure Commands" on page 290

• ":MARKer:Y1Position" on page 282

• ":MARKer:Y2Position" on page 283

• ":MARKer:YDELta" on page 284

• ":MARKer:X2Y2source" on page 280

• ":MEASure:SOURce" on page 315

• ":MEASure:TDELta" on page 681

• ":MEASure:TSTArt" on page 685

NOTE

The short form of this command, VSTO, does not follow the defined Long Form to Short

Form Truncation Rules (see page 752). The normal short form, VST, would be the same for

both VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.

NOTE

The :MEASure:VSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y2Position command (see page 283) instead.