Technical data

690 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

7 Obsolete and Discontinued Commands

:MEASure:VDELta

(see page 750)

Query Syntax

:MEASure:VDELta?

The :MEASure:VDELta? query returns the voltage difference between

vertical marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No

measurement is made when the :MEASure:VDELta? query is received by

the oscilloscope. The delta value that is returned is the current value. This

is the same value as the front- panel cursors delta Y value.

VDELta = value at marker 2 - value at marker 1

Return Format

<value> ::= delta V value in NR1 format

See Also • "Introduction to :MARKer Commands" on page 275

• "Introduction to :MEASure Commands" on page 290

• ":MARKer:Y1Position" on page 282

• ":MARKer:Y2Position" on page 283

• ":MARKer:YDELta" on page 284

• ":MEASure:TDELta" on page 681

• ":MEASure:TSTArt" on page 685

NOTE

The :MEASure:VDELta command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:YDELta command (see page 284) instead.