Technical data

Obsolete and Discontinued Commands 7

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 689

:MEASure:UPPer

(see page 750)

Command Syntax

:MEASure:UPPer <value>

The :MEASure:UPPer command sets the upper measurement threshold

value. This value and the LOWer value represent absolute values when the

thresholds are ABSolute and percentage when the thresholds are PERCent

as defined by the :MEASure:DEFine THResholds command.

Query Syntax

:MEASure:UPPer?

The :MEASure:UPPer? query returns the current upper threshold level.

Return Format

<value> ::= the user-defined upper threshold in NR3 format

See Also • "Introduction to :MEASure Commands" on page 290

• ":MEASure:LOWer" on page 679

• ":MEASure:THResholds" on page 682

NOTE

The :MEASure:UPPer command is obsolete and is provided for backward compatibility to

previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see page 294)

instead.