Technical data

660 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
Discontinued
Commands
Discontinued commands are commands that were used by previous
oscilloscopes, but are not supported by the InfiniiVision 5000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
:PRINt? (see page 701):DISPlay:DATA? (see
page 226)
:TIMebase:DELay (see
page 703)
:TIMebase:POSition (see
page 432) or
:TIMebase:WINDow:POSition
(see page 437)
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
:TRIGger:CAN:ACKNowledge
(see page 704)
none
:TRIGger:LIN:SIGNal:DEFinitio
n (see page 705)
none
:TRIGger:TV:TVMode (see
page 706)
:TRIGger:TV:MODE (see
page 566)
Obsolete Command Current Command Equivalent Behavior Differences
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 230)
CHANnel:MATH :FUNCtion:OPERation (see
page 252)
ADD not included
CHANnel<n>:PROTect :CHANnel<n>:PROTection
(see page 218)
Previous form of this
command was used to
enable/disable 50
protection. The new command
resets a tripped protect and
the query returns the status of
TRIPed or NORMal.
DISPlay:INVerse none
DISPlay:COLumn none
DISPlay:FREeze none
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none
DISPlay:POSition none
DISPlay:ROW none