Technical data

640 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
6 Commands A-Z
• ":FUNCtion:OFFSet" on page 251
• "*OPC (Operation Complete)" on page 122
• ":OPEE (Operation Status Enable Register)" on page 159
• OPERation Commands:
• ":FUNCtion:GOFT:OPERation" on page 248
• ":FUNCtion:OPERation" on page 252
• ":OPERegister:CONDition (Operation Status Condition Register)" on
page 161
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 163
• "*OPT (Option Identification)" on page 123
• OUTPut Commands:
• ":CALibrate:OUTPut" on page 197
• ":MTESt:OUTPut" on page 355
• OVERload, ":SBUS:CAN:COUNt:OVERload" on page 397
• OVERshoot, ":MEASure:OVERshoot" on page 303
• ":OVLenable (Overload Event Enable Register)" on page 165
• ":OVLRegister (Overload Event Register)" on page 167
P • PALette Commands:
• ":HARDcopy:PALette" on page 268
• ":SAVE:IMAGe:PALette" on page 385
• PARity Commands:
• ":SBUS:LIN:PARity" on page 408
• ":TRIGger:UART:PARity" on page 578
• PATTern Commands:
• ":TRIGger:CAN:PATTern:DATA" on page 454
• ":TRIGger:CAN:PATTern:DATA:LENGth" on page 455
• ":TRIGger:CAN:PATTern:ID" on page 456
• ":TRIGger:CAN:PATTern:ID:MODE" on page 457
• ":TRIGger:DURation:PATTern" on page 467
• ":TRIGger:I2S:PATTern:DATA" on page 505
• ":TRIGger:I2S:PATTern:FORMat" on page 507
• ":TRIGger:IIC:PATTern:ADDRess" on page 519
• ":TRIGger:IIC:PATTern:DATA" on page 520
• ":TRIGger:IIC:PATTern:DATa2" on page 521
•
":TRIGger:LIN:PATTern:DATA" on page 530