Technical data

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 615

:WAVeform:SOURce:SUBSource

(see page 750)

Command Syntax

:WAVeform:SOURce:SUBSource <subsource>

<subsource> ::= {{NONE | RX} | TX}

If the :WAVeform:SOURce is SBUS (serial decode), more than one data set

may be available, and this command lets you choose from the available

data sets.

Currently, only UART serial decode lets you get "TX" data. The default,

NONE, specifies "RX" data. (RX is an alias for NONE.)

If the :WAVeform:SOURce is not SBUS, or the :SBUS:MODE is not UART,

the only valid subsource is NONE.

Query Syntax

:WAVeform:SOURce:SUBSource?

The :WAVeform:SOURce:SUBSource? query returns the current waveform

subsource setting.

Return Format

<subsource> ::= {NONE | TX}

See Also • "Introduction to :WAVeform Commands" on page 592

• ":WAVeform:SOURce" on page 611