Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 607
See Also • "Introduction to :WAVeform Commands" on page 592
• ":ACQuire:COUNt" on page 181
• ":ACQuire:POINts" on page 184
• ":ACQuire:TYPE" on page 191
• ":DIGitize" on page 146
• ":WAVeform:COUNt" on page 598
• ":WAVeform:DATA" on page 599
• ":WAVeform:FORMat" on page 601
• ":WAVeform:POINts" on page 602
• ":WAVeform:TYPE" on page 616
• ":WAVeform:XINCrement" on page 619
• ":WAVeform:XORigin" on page 620
• ":WAVeform:XREFerence" on page 621
• ":WAVeform:YINCrement" on page 622
• ":WAVeform:YORigin" on page 623
• ":WAVeform:YREFerence" on page 624
Example Code
' GET_PREAMBLE - The preamble block contains all of the current
' WAVEFORM settings. It is returned in the form <preamble_block><NL>
' where <preamble_block> is:
' FORMAT : int16-0=BYTE, 1 = WORD, 4 = ASCII.
Y origin (V)
Y increment =
voltage of 1 Vstep
Y reference = #Vsteps / 2
X origin (t)
X increment (t) = time between successive points
X reference = 0
Delay = (#points / 2) * Xincrement + Xorigin
Offset
#Vsteps =
65536 (if format = WORD)
256 (if format = BYTE)