Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 587
:TRIGger:USB:SOURce:DPLus
(see page 750)
Command Syntax
:TRIGger:USB:SOURce:DPLus <source>
<source> ::= {CHANnel<n> | EXTernal}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:USB:SOURce:DPLus command sets the source for the USB D+
signal.
Query Syntax
:TRIGger:USB:SOURce:DPLus?
The :TRIGger:USB:SOURce:DPLus? query returns the current source for the
USB D+ signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:MODE" on page 447
• ":TRIGger:USB:SOURce:DMINus" on page 586
• ":TRIGger:USB:TRIGger" on page 589