Technical data

582 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:UART:SOURce:TX

(see page 750)

Command Syntax

:TRIGger:UART:SOURce:TX <source>

<source> ::= {CHANnel<n> | EXTernal}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:UART:SOURce:TX command controls which signal is used as

the Tx source by the serial decoder and/or trigger when in UART mode.

Query Syntax

:TRIGger:UART:SOURce:TX?

The :TRIGger:UART:SOURce:TX? query returns the current source for the

UART Tx signal.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:MODE" on page 447

• ":TRIGger:UART:TYPE" on page 583

• ":TRIGger:UART:BITorder" on page 574