Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 581
:TRIGger:UART:SOURce:RX
(see page 750)
Command Syntax
:TRIGger:UART:SOURce:RX <source>
<source> ::= {CHANnel<n> | EXTernal}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:UART:SOURce:RX command controls which signal is used as
the Rx source by the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:SOURce:RX?
The :TRIGger:UART:SOURce:RX? query returns the current source for the
UART Rx signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:MODE" on page 447
• ":TRIGger:UART:TYPE" on page 583
• ":TRIGger:UART:BITorder" on page 574