Technical data

572 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:UART:BASE

(see page 750)

Command Syntax

:TRIGger:UART:BASE <base>

<base> ::= {ASCii | HEX}

The :TRIGger:UART:BASE command sets the front panel UART/RS232

trigger setup data selection option:

• ASCii — front panel data selection is from ASCII values.

• HEX — front panel data selection is from hexadecimal values.

The :TRIGger:UART:BASE setting does not affect the :TRIGger:UART:DATA

command which can always set data values using ASCII or hexadecimal

values.

Query Syntax

:TRIGger:UART:BASE?

The :TRIGger:UART:BASE? query returns the current UART base setting.

Return Format

<base> ::= {ASC | HEX}

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:MODE" on page 447

• ":TRIGger:UART:DATA" on page 576

NOTE

The :TRIGger:UART:BASE command is independent of the :SBUS:UART:BASE command

which affects decode only.