Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 549
:TRIGger:SEQuence:EDGE
(see page 750)
Command Syntax
:TRIGger:SEQuence:EDGE{1 | 2} <source>, <slope>
<source> ::= {CHANnel<n> | EXTernal}
<slope> ::= {POSitive | NEGative}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:SEQuence:EDGE<n> command defines the specified sequencer
edge resource according to the specified <source> and <slope>. To disable
an edge resource, set its <source> to NONE. In this case, <slope> has no
meaning.
Query Syntax
:TRIGger:SEQuence:EDGE{1 | 2}?
The :TRIGger:SEQuence:EDGE<n>? query returns the specified sequencer
edge resource setting. If the edge resource is disabled, the returned
<source> value is NONE. In this case, the <slope> is undefined.
Return Format
<source>, <slope><NL>
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:SEQuence:FIND" on page 550
• ":TRIGger:SEQuence:TRIGger" on page 554
• ":TRIGger:SEQuence:RESet" on page 552
• ":TRIGger:SEQuence:COUNt" on page 548