Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 517
:TRIGger:I2S:WSLow
(see page 750)
Command Syntax
:TRIGger:I2S:WSLow <low_def>
<low_def> ::= {LEFT | RIGHt}
The :TRIGger:I2S:WSLow command selects the polarity of the word select
(WS) signal:
• LEFT— a word select (WS) state of low indicates left channel data is
active on the I2S bus, and a WS state of high indicates right channel
data is active on the bus.
• RIGHt — a word select (WS) state of low indicates right channel data is
active on the I2S bus, and a WS state of high indicates left channel
data is active on the bus.
Query Syntax
:TRIGger:I2S:WSLow?
The :TRIGger:I2S:WSLow? query returns the currently selected I2S word
select (WS) polarity.
Return Format
<low_def><NL>
<low_def> ::= {LEFT | RIGHt}
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:I2S:ALIGnment" on page 502
• ":TRIGger:I2S:CLOCk:SLOPe" on page 504
• ":TRIGger:I2S:RWIDth" on page 510
• ":TRIGger:I2S:TWIDth" on page 516