Technical data

512 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:I2S:SOURce:DATA

(see page 750)

Command Syntax

:TRIGger:I2S:SOURce:DATA <source>

<source> ::= {CHANnel<n> | EXTernal}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:I2S:SOURce:DATA command controls which signal is used as

the serial data (SDATA) source by the serial decoder and/or trigger when

in I2S mode.

Query Syntax

:TRIGger:I2S:SOURce:DATA?

The :TRIGger:I2S:SOURce:DATA? query returns the current source for the

I2S serial data (SDATA).

Return Format

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:I2S:SOURce:CLOCk" on page 511

• ":TRIGger:I2S:SOURce:WSELect" on page 513