Technical data

504 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:I2S:CLOCk:SLOPe

(see page 750)

Command Syntax

:TRIGger:I2S:CLOCk:SLOPe <slope>

<slope> ::= {NEGative | POSitive}

The :TRIGger:I2S:CLOCk:SLOPe command specifies which edge of the I2S

serial clock signal clocks in data.

• NEGative — Falling edge.

• POSitive — Rising edge.

Query Syntax

:TRIGger:I2S:CLOCk:SLOPe?

The :TRIGger:I2S:CLOCk:SLOPe? query returns the current I2S clock slope

setting.

Return Format

<slope> ::= {NEG | POS}

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:I2S:ALIGnment" on page 502

• ":TRIGger:I2S:RWIDth" on page 510

• ":TRIGger:I2S:TWIDth" on page 516

• ":TRIGger:I2S:WSLow" on page 517