Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 491
:TRIGger:FLEXray:TRIGger
(see page 750)
Command Syntax
:TRIGger:FLEXray:TRIGger <condition>
<condition> ::= {FRAMe | ERRor | EVENt}
The :TRIGger:FLEXray:TRIGger command sets the FLEXray trigger on
condition:
• FRAMe — triggers on specified frames (without errors).
• ERRor — triggers on selected active error frames and unknown bus
conditions.
• EVENt — triggers on specified FlexRay event/symbol.
Query Syntax
:TRIGger:FLEXray:TRIGger?
The :TRIGger:FLEXray:TRIGger? query returns the current FLEXray trigger
on condition.
Return Format
<condition><NL>
<condition> ::= {FRAM | ERR | EVEN}
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:MODE" on page 447
• ":TRIGger:FLEXray:ERRor:TYPE" on page 484
• ":TRIGger:FLEXray:EVENt:TYPE" on page 485
• ":TRIGger:FLEXray:FRAMe:CCBase" on page 486
• ":TRIGger:FLEXray:FRAMe:CCRepetition" on page 487
• ":TRIGger:FLEXray:FRAMe:ID" on page 488
• ":TRIGger:FLEXray:FRAMe:TYPE" on page 489
NOTE
This command is only valid when the FLEXray triggering and serial decode option (Option
FLX) has been licensed.