Technical data

490 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:FLEXray:SOURce
(see page 750)
Command Syntax
:TRIGger:FLEXray:SOURce <source>
<source> ::= {CHANnel<n>}
<n>::={1|2|3|4}
The :TRIGger:FLEXray:SOURce command specifies the input source for the
FlexRay signal.
Query Syntax
:TRIGger:FLEXray:SOURce?
The :TRIGger:FLEXray:SOURce? query returns the current source for the
FlexRay signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:FLEXray:TRIGger" on page 491
• ":TRIGger:FLEXray:EVENt:TYPE" on page 485
• ":TRIGger:FLEXray:AUTosetup" on page 481
NOTE
This command is only valid when the FLEXray triggering and serial decode option (Option
FLX) has been licensed.