Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 483
:TRIGger:FLEXray:CHANnel
(see page 750)
Command Syntax
:TRIGger:FLEXray:CHANnel <channel>
<channel> ::= {A | B}
The :TRIGger:FLEXray:CHANnel command specifies the bus channel, A or
B, of the FlexRay signal.
Query Syntax
:TRIGger:FLEXray:CHANnel?
The :TRIGger:FLEXray:CHANnel? query returns the current bus channel
setting.
Return Format
<channel><NL>
<channel> ::= {A | B}
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:FLEXray Commands" on page 480
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the FlexRay
triggering and serial decode option (Option FLX) has been licensed.