Technical data

470 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:EBURst Commands
The :TRIGger:EDGE:SOURce command is used to specify the source
channel for the Nth Edge Burst trigger. The :TRIGger:EDGE:LEVel
command is used to set the Nth Edge Burst trigger level.
Table 72 :TRIGger:EBURst Commands Summary
Command Query Options and Query Returns
:TRIGger:EBURst:COUNt
<count> (see
page 471)
:TRIGger:EBURst:COUNt
? (see page 471)
<count> ::= integer in NR1 format
:TRIGger:EBURst:IDLE
<time_value> (see
page 472)
:TRIGger:EBURst:IDLE?
(see page 472)
<time_value> ::= time in seconds
in NR3 format
:TRIGger:EBURst:SLOPe
<slope> (see
page 473)
:TRIGger:EBURst:SLOPe
? (see page 473)
<slope> ::= {NEGative | POSitive}