Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 461
:TRIGger:CAN:SOURce
(see page 750)
Command Syntax
:TRIGger:CAN:SOURce <source>
<source> ::= {CHANnel<n> | EXTernal}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:CAN:SOURce command sets the source for the CAN signal.
The source setting is only valid when :TRIGger:CAN:TRIGger is set to SOF
(start of frame).
Query Syntax
:TRIGger:CAN:SOURce?
The :TRIGger:CAN:SOURce? query returns the current source for the CAN
signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 440
• ":TRIGger:MODE" on page 447
• ":TRIGger:CAN:TRIGger" on page 462
• ":TRIGger:CAN:SIGNal:DEFinition" on page 460