Technical data

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 459

:TRIGger:CAN:SIGNal:BAUDrate

(see page 750)

Command Syntax

:TRIGger:CAN:SIGNal:BAUDrate <baudrate>

<baudrate> ::= integer from 10000 to 1000000 in 100 b/s increments

The :TRIGger:CAN:SIGNal:BAUDrate command sets the standard baud rate

of the CAN signal from 10 kb/s to 1 Mb/s in 100 b/s increments. If you

enter a baud rate that is not divisible by 100 b/s, the baud rate is set to

the nearest baud rate divisible by 100 b/s.

If the baud rate you select does not match the system baud rate, false

triggers may occur.

Query Syntax

:TRIGger:CAN:SIGNal:BAUDrate?

The :TRIGger:CAN:SIGNal:BAUDrate? query returns the current CAN baud

rate setting.

Return Format

<baudrate> ::= integer from 10000 to 1000000 in 100 b/s increments

See Also • "Introduction to :TRIGger Commands" on page 440

• ":TRIGger:MODE" on page 447

• ":TRIGger:CAN:TRIGger" on page 462

• ":TRIGger:CAN:SIGNal:DEFinition" on page 460

• ":TRIGger:CAN:SOURce" on page 461