Technical data

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 415
:SBUS:UART:COUNt:RESet
(see page 750)
Command Syntax
:SBUS:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "- 241, Hardware missing" on page 709
See Also • ":SBUS:UART:COUNt:ERRor" on page 414
• ":SBUS:UART:COUNt:RXFRames" on page 416
• ":SBUS:UART:COUNt:TXFRames" on page 417
• "Introduction to :SBUS Commands" on page 395
• ":SBUS:MODE" on page 410
• ":TRIGger:UART Commands" on page 570
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.