Technical data

410 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SBUS:MODE
(see page 750)
Command Syntax
:SBUS:MODE <mode>
<mode> ::= {CAN | FLEXray | I2S | IIC | LIN | M1553 | SPI | UART}
The :SBUS:MODE command determines the decode mode for the serial
bus.
Query Syntax
:SBUS:MODE?
The :SBUS:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {CAN | FLEX | I2S | IIC | LIN | M1553 | SPI | UART | NONE}
Errors • "- 241, Hardware missing" on page 709
See Also • "Introduction to :SBUS Commands" on page 395
• ":TRIGger:MODE" on page 447
• ":TRIGger:CAN Commands" on page 452
• ":TRIGger:FLEXray Commands" on page 480
• ":TRIGger:I2S Commands" on page 500
• ":TRIGger:IIC Commands" on page 518
• ":TRIGger:LIN Commands" on page 527
• ":TRIGger:M1553 Commands" on page 540
• ":TRIGger:SPI Commands" on page 555
• ":TRIGger:UART Commands" on page 570
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
option has been licensed.