Technical data

406 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SBUS:I2S:BASE
(see page 750)
Command Syntax
:SBUS:I2S:BASE <base>
<base> ::= {DECimal | HEX}
The :SBUS:I2S:BASE command determines the base to use for the I2S
decode display.
Query Syntax
:SBUS:I2S:BASE?
The :SBUS:I2S:BASE? query returns the current I2S display decode base.
Return Format
<base><NL>
<base> ::= {DECimal | HEX}
Errors • "- 241, Hardware missing" on page 709
See Also • "Introduction to :SBUS Commands" on page 395
• ":TRIGger:I2S Commands" on page 500
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the I2S serial
decode option (Option SND) has been licensed.