Technical data

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 401

:SBUS:DISPlay

(see page 750)

Command Syntax

:SBUS:DISPlay <display>

<display> ::= {{1 | ON} | {0 | OFF}}

The :SBUS:DISPlay command turns displaying of the serial decode bus on

or off.

Query Syntax

:SBUS:DISPlay?

The :SBUS:DISPlay? query returns the current display setting of the serial

decode bus.

Return Format

<display> ::= {0 | 1}

Errors • "- 241, Hardware missing" on page 709

See Also • "Introduction to :SBUS Commands" on page 395

• ":CHANnel<n>:DISPlay" on page 208

• ":VIEW" on page 176

• ":BLANk" on page 144

• ":STATus" on page 173

NOTE

This command is only valid on 4 (analog) channel oscilloscope models when a serial decode

option has been licensed.