Technical data

342 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:MTESt:AMASk:CREate
(see page 750)
Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask
around the current selected channel, using the tolerance parameters
defined by the :MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and
:MTESt:AMASk:UNITs commands. The mask only encompasses the portion
of the waveform visible on the display, so you must ensure that the
waveform is acquired and displayed consistently to obtain repeatable
results.
The :MTESt:SOURce command selects the channel and should be set before
using this command.
See Also • "Introduction to :MTESt Commands" on page 339
• ":MTESt:AMASk:XDELta" on page 345
• ":MTESt:AMASk:YDELta" on page 346
• ":MTESt:AMASk:UNITs" on page 344
• ":MTESt:AMASk:SOURce" on page 343
• ":MTESt:SOURce" on page 369
Example Code • "Example Code" on page 339