Technical data

What's New 1
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 33
What's New in Version 5.00
New features in version 5.00 of the InfiniiVision 5000 Series oscilloscope
software are:
• Serial triggering and decode options are now available.
• The :SAVE and :RECall command subsystems.
• Changes to the :HARDcopy command subsystem to make a clearer
distinction between printing and save/recall functionality.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Description
:HARDcopy:STARt (see page 270) Starts a print job.
:HARDcopy:APRinter (see page 263) Sets the active printer.
:HARDcopy:AREA (see page 262) Specifies the area of the display to print
(currently SCReen only).
:HARDcopy:INKSaver (see page 266) Inverts screen colors to save ink when printing.
:HARDcopy:PRinter:LIST (see page 269) Returns a list of the available printers.
:RECall Commands (see page 371) Commands for recalling previously saved
oscilloscope setups and traces.
:SAVE Commands (see page 377) Commands for saving oscilloscope setups and
traces, screen images, and data.
:SBUS Commands (see page 394) Commands for controlling oscilloscope
functions associated with the serial decode
bus.
:TRIGger:CAN Commands (see page 452) Commands for triggering on Controller Area
Network (CAN) version 2.0A and 2.0B signals.
:TRIGger:IIC Commands (see page 518) Commands for triggering on Inter-IC (IIC)
signals.
:TRIGger:LIN Commands (see page 527) Commands for triggering on Local Interconnect
Network (LIN) signals.
:TRIGger:SPI Commands (see page 555) Commands for triggering on Serial Peripheral
Interface (SPI) signals.
:TRIGger:UART Commands (see page 570) Commands for triggering on UART/RS-232
signals.
:WAVeform:SOURce:SUBSource (see
page 615)
Selects subsource when :WAVeform:SOURce
is SBUS (serial decode).