Technical data

298 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

Vtop. If you want to move the delay measurement point nearer to Vtop or

Vbase, you must change the threshold values with the :MEASure:DEFine

THResholds command.

Return Format

<value> ::= floating-point number delay time in seconds in NR3 format

See Also • "Introduction to :MEASure Commands" on page 290

• ":MEASure:DEFine" on page 294

• ":MEASure:PHASe" on page 306