Technical data

284 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:MARKer:YDELta

(see page 750)

Query Syntax

:MARKer:YDELta?

The :MARKer:YDELta? query returns the value difference between the

current Y1 and Y2 cursor positions.

Ydelta = (Value at Y2 cursor) - (Value at Y1 cursor)

Return Format

<value> ::= difference value in NR3 format

See Also • "Introduction to :MARKer Commands" on page 275

• ":MARKer:MODE" on page 276

• ":MARKer:X1Y1source" on page 278

• ":MARKer:X2Y2source" on page 280

• ":MARKer:Y1Position" on page 282

• ":MARKer:Y2Position" on page 283

NOTE

If the front-panel cursors are off or are set to Binary or Hex Mode, the marker position

values are not defined. Make sure to set :MARKer:MODE to MANual or WAVeform to put

the cursors in the front-panel Normal mode.