Technical data

26 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
1 What's New
Changed
Commands
:TRIGger:SEQuence Commands (see page 547) Commands for triggering the oscilloscope after
finding a sequence of events.
:TRIGger:USB Commands (see page 585) Commands for triggering on a Start of Packet
(SOP), End of Packet (EOP), Reset Complete,
Enter Suspend, or Exit Suspend signal on the
differential USB data lines. USB Low Speed and
Full Speed are supported by this trigger.
Command Description
Command Differences
:SBUS:MODE (see page 410) You can now select the I2S serial bus decode
mode.
:TRIGger:LIN:TRIGger (see page 539) You can now select the DATA option for
triggering on a LIN frame ID and data.
:TRIGger:MODE (see page 447) You can now select the EBURst, I2S,
SEQuence, and USB trigger modes.
:TRIGger:TV:STANdard (see page 569) The P1080L50HZ and P1080L60HZ standards
have been added.