Technical data

What's New 1
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 25
What's New in Version 5.25
New features in version 5.25 of the InfiniiVision 5000 Series oscilloscope
software are:
• The Lister display for showing decoded serial data in tabular format.
• The ability to trigger on and decode I2S serial bus data with a
four-channel oscilloscope that includes the Option SND license.
• The EBURst trigger mode and supporting :TRIGger:EBURst commands.
• The SEQuence trigger mode and supporting :TRIGger:SEQuence
commands.
• The USB trigger mode and supporting :TRIGger:USB commands.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Description
:CHANnel<n>:PROBe:HEAD[:TYPE] (see
page 214)
Sets an analog channel probe head type and dB
value.
:DISPlay:FREeze Freezes the display without stopping currently
running acquisitions.
:LISTer Commands (see page 271) Commands for turning the Lister display on/off
and for returning the Lister data.
:MTESt:RMODe:FACTion:MEASure (see
page 357)
Lets you enable or disable measurements on
mask test failures.
:SAVE:LISTer[:STARt] (see page 386) Saves the Lister display data to a file.
:SBUS:I2S:BASE (see page 406) Determines the base to use for the I2S decode
display.
:TRIGger:EBURst Commands (see page 470) Commands for triggering on the Nth edge of a
burst that occurs after an idle time.
:TRIGger:I2S Commands (see page 500) Commands for triggering on I2S signals.
:TRIGger:LIN:PATTern:DATA (see page 530) Sets the data value when triggering on a LIN
frame ID and data.
:TRIGger:LIN:PATTern:DATA:LENGth (see
page 532)
Sets the byte length of the LIN data string.
:TRIGger:LIN:PATTern:FORMat (see page 533) Sets the entry (and query) number base used
by the :TRIGger:LIN:PATTern:DATA command.