Technical data

What's New 1
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 23
What's New in Version 6.00
New features in version 6.00 of the InfiniiVision 5000 Series oscilloscope
software are:
• The ability to perform measurements and math functions on a
10K- point (maximum) precision analysis data record.
• Support for the new N5469A MIL- STD 1553 triggering and decode
option (Option 553).
• Support for the new N5432C FlexRay triggering and decode option
(Option FLX).
More detailed descriptions of the new and changed commands appear
below.
New Commands
Changed
Commands
Command Description
:SBUS:FLEXray:COUNt:NULL? (see page 402) Returns the FlexRay null frame count.
:SBUS:FLEXray:COUNt:RESet (see page 403) Resets the FlexRay frame counters.
:SBUS:FLEXray:COUNt:SYNC? (see page 404) Returns the FlexRay sync frame count.
:SBUS:FLEXray:COUNt:TOTal? (see page 405) Returns the FlexRay total frame count.
:SBUS:M1553:BASE (see page 409) Determines the base to use for the MIL-STD
1553 decode display.
:SBUS:SPI:BITorder (see page 411) Selects the bit order used when displaying data
in the SPI serial decode waveform and in the
Lister.
:SYSTem:PRECision (see page 424) Allows measurements and math functions to
be performed on a precision analysis record (at
the expense of waveform update rate).
:TRIGger:FLEXray Commands (see page 500) Commands for triggering on FlexRay signals.
:TRIGger:M1553 Commands (see page 540) Commands for triggering on MIL-STD 1553
signals.
Command Differences
:SBUS:MODE (see page 410) You can now select the M1553 serial bus
decode mode.
:TRIGger:MODE (see page 447) You can now select the M1553 trigger mode.