Technical data

22 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
1 What's New
What's New in Version 6.10
New features in version 6.10 of the InfiniiVision 5000 Series oscilloscope
software are:
• When the zoomed time base mode is on, you can select whether the
Main window or the Zoom window is used as the measurement window.
• An interval specification for the V average and dc RMS measurements
has been added.
• A 50% trigger level command.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Changed
Commands
Command Description
:MEASure:WINDow (see page 334) When the zoomed time base mode is on,
specifies whether the Main window or the
Zoom window is used as the measurement
window.
:TRIGger:LFIFty (see page 446) Sets the trigger level of a displayed analog
channel trigger source to the waveform's 50%
value.
Command Differences
:MEASure:VAVerage (see page 325) There is now an option for specifying the
interval.
:MEASure:VRMS (see page 331) There is now an option for specifying the
interval.
:TRIGger:CAN:SIGNal:DEFinition (see
page 460)
There are now DIFH (differential H-L) and DIFL
(differential L-H) options. The DIFL option is the
same as the existing DIFFerential option. Also,
this command is no longer classified as
obsolete.