User`s guide
10 Serial Decode/Lister
300 InfiniiVision Oscilloscopes User’s Guide
FlexRay Serial Decode
To trigger on FlexRay data, you need:
• A four-channel MSO6000 or MSO7000 Series mixed signal oscilloscope
• Option FRS (N5432B) FlexRay triggering and decode, which includes:
• Agilent VPT1000 protocol analyzer module
• MSO communications cable
Option FRS allows you to:
• Control the VPT1000 (without a PC).
• Trigger on FlexRay bus frames, synchronous timing slots/segments, or error
conditions.
• Display decoded FlexRay bus data and synchronous timing.
For information regarding updating the VPT1000 IP address or updating VPT1000
firmware, see page 416.
To display decoded FlexRay data
1 Set up communication between the oscilloscope and the VPT1000. See “Setting Up
the Oscilloscope and the VPT1000” on page 107.
2 For FlexRay triggering set up, see “Triggering on FlexRay Frames, Times, Errors, or
Events” on page 111.
While decoding FlexRay data, you can use FlexRay trigger or another trigger type, such
as duration, I
2
C, Nth edge burst, sequence, SPI, or USB. When the oscilloscope is in
FlexRay trigger mode, only FlexRay decode is available.
3 Select the FlexRay serial decode mode:
a Press the [Acquire] key.
b Press the Serial Decode softkey.
NOTE
For FlexRay triggering setup see page 106.