User`s guide

Triggering 4

InfiniiVision Oscilloscopes User’s Guide 111

Triggering on FlexRay Frames, Times, Errors, or Events

1 To trigger on FlexRay data, you must first set up communication between the

oscilloscope and the VPT1000. See “Setting Up the Oscilloscope and the

VPT1000” on page 107.

2 In the Trigger section on the front panel, press the [More] key.

3 Press the Trigger softkey, and use the Entry knob to select FlexRay.

4 Press the Settings softkey to access the FlexRay Trigger Menu.

Triggering on FlexRay Frames

1 In the FlexRay Trigger Menu press the Trigger softkey, and use the Entry knob to select

Frame.

2 Press the Frames softkey to access the FlexRay Frame Trigger Menu.

NOTE

Before powering-off the oscilloscope, it is recommended that you change the VPT1000

mode to PC.

If oscilloscope is shut off while in Asynchronous or Synchronous modes, communication

with the VPT1000 will not be automatically restored up on power up. To restore

communication with the VPT1000, cycle the VPT1000 power, wait for its State indicator

to turn from red to green, and then press the Mode softkey (in the VPT1000 Menu) on the

oscilloscope to cycle through the modes.

FlexRay

trigger

Trigger

condition

VPT1000

Return to

previous menu

Open Frame

Trigger Menu