User`s manual

20
Oscilloscopes redefined: Breakthrough technology delivers more scope for the same budget
Performance characteristics
Vertical system digital channels
All MSO 3000 X-Series models and on all DSO 3000 X-Series models with after
purchase upgrade
Characteristics
Digital input channels 16 digital (D0 to D15)
Thresholds Threshold per set of 8 channels
Threshold selections TTL (+1.4 V)
5 V CMOS (+2.5 V)
ECL (–1.3 V)
User-definable (selectable by pod)
User-defined threshold range ±8.0 V in 10 mV steps
Maximum input voltage ±40 V peak CAT I; transient overvoltage 800 Vpk
Threshold accuracy* ±(100 mV + 3% of threshold setting)
Maximum input dynamic range ±10 V about threshold
Minimum voltage swing 500 mVpp
Input impedance 100 kΩ ±2% II at probe tip
Probe loading ~8 pF
Vertical resolution 1 bit
Horizontal system analog channels
All 3000 X-Series models
Characteristics
Maximum sample rate 2 GSa/sec, 4 GSa/s half-channel interleaved
Maximum record length 1 Mpts (digital only), 250 kpts (analog and digital channels) standard
2 Mpts (digital only), 500Kpts (analog and digital channels) with 4M memory upgrade
(DSOX3MEMUP)
Maximum duration of time captured
at highest sample rate (all channels)
2 Mpts (digital only), 500Kpts (analog and digital channels) with 4M memory upgrade
(DSOX3MEMUP)
DSOX3012A
MSOX3012A
DSOX3014A
MSOX3014A
DSOX3024A
MSOX3024A
DSOX3032A
MSOX3032A
DSOX3034A
MSOX3034A
DSOX3052A
MSOX3052A
DSOX3054A
MSOX3054A
Time base range
(s/div)
5 ns/div to
50 s/div
5 ns/div to
50 s/div
2 ns/div to
50 s/div
2 ns/div to
50 s/div
2 ns/div to
50 s/div
1 ns/div to
50 s/div
1 ns/div to
50 s/div
All 3000 X-Series models
Time base delay time range Pre-trigger – Greater of 1 screen width or 200 µs
Post-trigger – 1 s to 500 s
Channel-to-channel deskew range ± 100 ns
Time base accuracy* 25 ppm ± 5 ppm per year (aging)
∆ Time accuracy (using cursors) ±(time base acc. x reading) ± (0.0016 x screen width) ± 100 ps
Modes Main, zoom, roll, XY
XY On channels 1 and 2 only Z Blanking on Ext Trigger Input, 1.4 V threshold Bandwidth:
Maximum bandwidth Phase error at 1 MHz: < 0.5 degree
* Denotes warranted specifications, all others are typical.
Specifications are valid after a 30-minute warm-up period and ±10 °C from firmware calibration temperature.