Technical data

Table Of Contents
Obsolete and Discontinued Commands 32
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 811
:MTESt:{STARt | STOP}
(see page 860)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition
system.
See Also "Introduction to :MTESt Commands" on page 387
NOTE
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for
backward compatibility to previous oscilloscopes. Use the :RUN command (see page 180)
and :STOP command (see page 184) instead.