Technical data

Table Of Contents
688 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
28 :TRIGger Commands
:TRIGger:SHOLd:SOURce:DATA
(see page 860)
Command Syntax
:TRIGger:SHOLd:SOURce:DATA <source>
<source> ::= {CHANnel<n> | EXTernal} for DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :TRIGger:SHOLd:SOURce:DATA command selects the channel used to
produce the trigger.
Query Syntax
:TRIGger:SHOLd:SOURce:DATA?
The :TRIGger:SHOLd:SOURce:DATA? query returns the current setup and
hold trigger source.
Return Format
<source><NL>
<source> ::= {CHAN<n> | EXT} for DSO models
<source> ::= {CHAN<n> | DIG<d>} for MSO models
See Also "Introduction to :TRIGger Commands" on page 641
":TRIGger:MODE" on page 648
":TRIGger:SHOLd:SLOPe" on page 686