Technical data

512 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:LIN:TRIGger
(see page 860)
Command Syntax
:SBUS<n>:LIN:TRIGger <condition>
<condition> ::= {SYNCbreak | ID | DATA}
The :SBUS<n>:LIN:TRIGger command sets the LIN trigger condition to be:
• SYNCbreak — Sync Break.
• ID — Frame ID.
Use the :SBUS<n>:LIN:ID command to specify the frame ID.
• DATA — Frame ID and Data.
Use the :SBUS<n>:LIN:ID command to specify the frame ID.
Use the :SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth and
:SBUS<n>:LIN:TRIGger:PATTern:DATA commands to specify the data
string length and value.
Query Syntax :SBUS<n>:LIN:TRIGger?
The :SBUS<n>:LIN:TRIGger? query returns the current LIN trigger value.
Return Format
<condition><NL>
<condition> ::= {SYNC | ID | DATA}
Errors • "- 241, Hardware missing" on page 823
See Also • "Introduction to :TRIGger Commands" on page 641
• ":TRIGger:MODE" on page 648
• ":SBUS<n>:LIN:TRIGger:ID" on page 513
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth" on page 516
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA" on page 514
• ":SBUS<n>:LIN:SIGNal:DEFinition" on page 816
• ":SBUS<n>:LIN:SOURce" on page 509