Technical data

288 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
16 :HARDcopy Commands
Introduction to
:HARDcopy
Commands
The HARDcopy subsystem provides commands to set and query the
selection of hardcopy device and formatting options such as inclusion of
instrument settings (FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this
case, the query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
:HARDcopy:NETWork:PAS
Sword <password> (see
page 298)
n/a <password> ::= quoted ASCII
string
:HARDcopy:NETWork:SLO
T <slot> (see
page 299)
:HARDcopy:NETWork:SLO
T? (see page 299)
<slot> ::= {NET0 | NET1}
:HARDcopy:NETWork:USE
Rname <username> (see
page 300)
:HARDcopy:NETWork:USE
Rname? (see page 300)
<username> ::= quoted ASCII
string
:HARDcopy:PALette
<palette> (see
page 301)
:HARDcopy:PALette?
(see page 301)
<palette> ::= {COLor | GRAYscale
| NONE}
n/a :HARDcopy:PRINter:LIS
T? (see page 302)
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
:HARDcopy:STARt (see
page 303)
n/a n/a
Table 76 :HARDcopy Commands Summary (continued)
Command Query Options and Query Returns