Specifications

26 | Keysight | InniiVision 3000T X-Series Oscilloscopes - Data Sheet
Performance characteristics
DSO and MSO 3000 X-Series oscilloscopes
Vertical system analog channels
Hardware bandwidth limits Approximately 20 MHz (selectable)
Input coupling
AC, DC
Input impedance Selectable: 1 MΩ ± 1% (14 pF), 50 Ω ± 1.5%
Input sensitivity range 100 MHz ~ 500 MHz models: 1 mV/div to 5 V/div
2
(1 MΩ and 50 Ω)
1 GHz models: 1 mV/div to 5 V/div
2
(1 MΩ), 1 mV/div to 1 V/div (50 Ω)
Vertical resolution 8 bits (measurement resolution is 12 bits with averaging)
Maximum input voltage
300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
With N2843A 10:1 probe: 300 Vrms
Frequency de-rating (assumes sine wave input): 400 Vpk until 40 kHz. Then de-rates at 20 db/dec until 6 Vpk
DC vertical accuracy ±[DC vertical gain accuracy + DC vertical offset accuracy + 0.25% full scale]
2
DC vertical gain accuracy
1
± 2.0% full scale
2
DC vertical offset accuracy ± 0.1 div ± 2 mV ± 1% of offset setting
Channel-to-channel isolation > 100:1 from DC to maximum specied bandwidth of each model
(measured with same V/div and coupling on channels)
Offset range ± 2 V (1 mV/div to 200 mV/div)
± 50 V (> 200 mV/div to 5 V/div)
1. Denotes warranted specications, all others are typical.
2. Specications are valid after a 30-minute warm-up period and ± 10 °C from rmware calibration temperature. 1 mV/div and 2 mV/div are a magnication of
4 mV/div setting. For vertical accuracy calculations, use full scale of 32 mV for 1 mV div and 2 mV/div sensitivity setting.
Vertical system digital channels
Digital input channels 16 digital (D0 to D15. pod 1: D7 ~ D0, Pod 2: D15 ~ D8)
Thresholds Threshold per pod
Threshold selections TTL (+1.4 V), 5V CMOS (+2.5 V), ECL (–1.3 V), user-dened (selectable by pod)
User-dened threshold range ± 8.0 V in 10 mV steps
Maximum input voltage ± 40 V peak CAT I; transient overvoltage 800 Vpk
Threshold accuracy
1
± (100 mV + 3% of threshold setting)
Maximum input dynamic range ± 10 V about threshold
Minimum voltage swing 500 mVpp
Input impedance 100 kΩ ± 2% at probe tip
Input capacitance ~8 pF
Vertical resolution 1 bit
3000T X-Series specication overview
3012T 3014T 3022T 3024T 3032T 3034T 3052T 3054T 3102T 3104T
Bandwidth
1
(-3dB) 100 MHz 200 MHz 350 MHz 500 MHz 1 GHz
Calculated rise time (10-90%) ≤ 3.5 ns ≤ 1.75 ns ≤ 1 ns ≤ 700 ps ≤ 450 ps
Input channels
DSOX 2 4 2 4 2 4 2 4 2 4
MSOX 2 + 16 4 + 16 2 + 16 4 + 16 2 + 16 4 + 16 2 + 16 4 + 16 2 + 16 4 + 16
Maximum sample rate 5 GSa/s all channels, 2.5 GSa/s half channels
Maximum memory depth Standard 4 Mpts, Standard segmented memory
Display size and type 8.5-inch capacitive touch gesture-enabled display
Waveform update rate > 1,000,000 waveforms per second