User`s guide

36 Agilent Infiniium 90000 X-Series Oscilloscopes User’s Guide
2 Using the Oscilloscope
Setting the Oscilloscope to a Known Starting Condition
You can set up the oscilloscope for many different kinds of complex
measurements.
• To automatically configure the oscilloscope for the current input
signal(s), press the [Auto Scale] key or select Control > Autoscale from the
menu bar.
• To reset the oscilloscope to its default setup, press the [Default Setup]
key or choose Control > Default Setup.
• If you use the [Default Setup] key with the graphical interface enabled,
you can choose Control > Undo Default Setup to return the oscilloscope to
its original configuration.
Figure 14 Setup Control Keys
'HIDXOW
6HWXS
$XWR
6FDOH
NOTE
Save the Current Oscilloscope Configuration
Before using [Default Setup], you may want to save the current oscilloscope configuration
for later use. See the online help (described in chapter 3) for instructions on saving and
recalling setups, and for information on the exact configuration that is set when you press
[Default Setup].