Specifications
Chapter 5: Replacing Assemblies
Removing and Replacing the Acquisition Boards/Backplane Assembly
94
Removing and Replacing the Acquisition Boards/Backplane
Assembly
Use these procedures to remove and replace the acquisition and backplane
assemblies and individual acquisition boards. When necessary, refer to other
removal procedures. The graphics in this chapter are representative of the
oscilloscope at the time of this printing. Your unit may look different.
Removing the acquisition and backplane assemblies
1 Remove the top panel, power supply, front panel assembly, and bottom panel
as described previously.
2 Remove all cables connected to the backplane board.
Figure 5-52
3
Remove the two M4 screws from the backplane tray (one in each corner).
Figure 5-53
4
Turn the oscilloscope over.