Specifications

Chapter 5: Replacing Assemblies

Removing and Replacing RealEdge Components

This section describes how to remove and replace the RealEdge modules and

the attenuator components of the RealEdge assembly.

1 Remove the RealEdge assembly as described previously.

2 Remove the two screws from the back of the top RealEdge module as shown

below. When replacing, torque to 5 in-lbs.

Figure 5-46

Loosen the connection between the RealEdge SMA connector and the attenuator

connector. Be careful to handle the RealEdge module by the casing and not the

connector. When tightening, torque the connector to 8 in- lbs.

Figure 5-47