Specifications

Chapter 5: Replacing Assemblies
Removing and Replacing Front Panel Assembly Parts
88
6
The front circuit board of the keyboard assembly is connected to the front bezel.
If you need to remove and replace only this front board, push the snap tabs
out of way with a screwdriver and pull out the board.
7 Disconnect the autoprobe cable and backlight cable.
Figure 5-39
8
Remove the two M3 screws, top right and bottom left, connecting the rear board
of the keyboard assembly to the deck, and remove the board. When reinstalling,
torque to 5 in- lbs.
Figure 5-40
9 To reassemble the front panel assembly, reverse these steps.