Specifications

Chapter 5: Replacing Assemblies
Removing and Replacing the Front Panel Assembly and Bottom Panel
81
6
Disconnect each input cable from each of the four attenuator connectors using
a 5/16- inch Hex torque wrench. When reconnecting, torque to 8 in- lbs. The
length of the cable will guide the installation (longest cable on left, shortest
cable on right).
Figure 5-22
7
Disconnect the attenuator power cable from each input channel attenuator.
Figure 5-23
8
Disconnect the Probe Comp cable from the connector on the backplane board.
Figure 5-24