Specifications

Chapter 5: Replacing Assemblies
Removing and Replacing the Top Panel and Motherboard
72
Removing and Replacing the Top Panel and Motherboard
Note that all sheet metal holes that are supposed to have screws placed in them
are marked by lines on four sides of the hole.
1 Remove the four M3 screws that connect the top panel to the rear. When
replacing, use a Torx T10 to torque to 5 in- lbs.
Figure 5-1
2
Slide the top panel back 1 to 2 inches and then lift it off. If necessary, gently
pry it using a flat- blade screwdriver at the rear lip.
Figure 5-2
Figure 5-3