Specifications

Chapter 1: General Information
Accessories supplied
7
Accessories supplied
The following accessories are supplied.
•Mouse
•Stylus
•Keyboard
• Front panel cover
• Calibration cable (the 50 GHz and 62 GHz bandwidth models include a second
calibration cable for the RealEdge inputs)
• Connector Savers (qty. 5 for 20 GHz, 25 GHz, and 33 GHz; additional 2 for 50 GHz
and 62 GHz)
• Power cord (see parts list in chapter 6 for country- dependent part number)
Specifications and Characteristics
The following table contains a partial list of specifications and characteristics for the
Agilent Infiniium 90000 Q- Series oscilloscopes. For a full list of specifications and
characteristics, see the data sheets at www.agilent.com/find/90000q- series.
Specifications that are pertinent to each test are in the "Testing Performance" chapter.
Specifications are valid after a 30- minute warm- up period, and within
± 5° C from the
temperature at which the last self- calibration was performed.
Environment Indoor use only.
Ambient
temperature
Operating 5 °C to +40 °C
Non-operating –40 °C to +65 °C
Humidity Operating: up to 95% relative humidity (non-condensing) at +40 °C
Non-operating: up to 90% relative humidity at +65 °C
Altitude Operating: up to 4,000 m (12,000 feet)
Non-operating: up to 15,300 meters (50,000 feet)
Installation/
Measurement
Category
Installation category: 2.
Measurement category: 1
Power Requirements 100-240 V, 47-63 Hz; 800 W Max for 4-channel models.
100-240 V, 50 Hz;100-208 V, 50/60 Hz; 800 W Max for 8-channel models.
Voltage Fluctuations Note that the mains supply voltage fluctuations are not to exceed +/-10% of the
nominal supply voltage.
Pollution Degree The Infiniium 90000 X-Series oscilloscopes may be operated in environments of
Pollution Degree 2.
Pollution Degree
Definitions
Pollution Degree 1: No pollution or only dry, non-conductive pollution occurs. The
pollution has no influence. Example: A clean room or climate-controlled office
environment.
Pollution Degree 2. Normally only dry non-conductive pollution occurs. Occasionally a
temporary conductivity caused by condensation may occur. Example: General indoor
environment.
Pollution Degree 3: Conductive pollution occurs, or dry, non-conductive pollution
occurs which becomes conductive due to condensation which is expected. Example:
Sheltered outdoor environment.